Installer Setting - Installer Setting Code Table - LG MFL61971220 Installation Manual

Installer Setting - Installer Setting Code Table

No. Function
0 Mode Override
Ceiling Height
1
Selection
Group Control
2
Auxiliary heater
Mode Override
This Function is only for Non-Auto Changeover H/P model.
Ceiling Height Selection
Indoor unit connected to wired remote controller operate as wired remote controller setting.
Group Control
This function is only for group control. Please don't set this function in case of non-group
control.
After setting Group Control of the product, turn off the power then turn it back on after 1
minute.
Auxiliary heater
This function is only applied to models with Auxiliary Heater function being activated.
Function Code
0 : Set to Master
0
1 : Set to Slave
1 : Standard
2 : Low
1
3 : High
4 : Super High
0 : Set to Master
2
1 : Set to Slave
2 : Check Master/Slave
3 : Set to Auxiliary heater
2
4 : Cancel Auxiliary heater
5 : Check Auxiliary heater Installation
INSTALLATION INSTRUCTIONS
Setting Value
17
Remote Controller LCD