Table of Contents
Advertisement
ADEUNIS RF - SIGFOX EUROPE demonstrator - USER GUIDE V1.1
4. Switching the product on
When you switch the ON/OFF button towards the right, the product is switched on and starts in nominal mode.
OFF Position
4.1.
Nominal mode
•
On power-up, LED 2 lights up with a continuous red light for a maximum of 8 minutes. This phase corresponds to the GPS's ini-
tialisation/synchronisation phase. The length of this phase is dynamic: if the GPS synchronises before the period of 8 minutes has
elapsed, LED2 will become orange and the initialisation phase will end 50 seconds later. During the GPS's initialisation phase, no
action is possible (no transmission of RF frames).
•
Once this initialisation phase has been completed, the product enters the nominal operating cycle. This cycle is composed of 5
stages.
1 – LED 1 green with rapid flashing (2 times), LED 2 continuous
red after 3 seconds.
2 – LED 1 flashing red 3 times
3 – LED 1 continuous green while waiting and during reception
4 – LED 1 flashes red once
5 – LED 1 flashes green 5 times and rapidly
The cycle is repeated periodically, every 10 minutes.
A diagram is given in APPENDIX 2 with a visual description of the nominal cycle.
4.2. Manual triggering of frame transmission
There are two ways of triggering frame transmission manually. Frames can only be sent between two cycles of nominal operation.
When a nominal operating cycle is being executed, users can do nothing.
4.2.1 Pressing BP1
Pressing BP1 triggers the execution of a nominal cycle, and the transmission of SIGFOX frames.
4.2.2 Accelerometer
The remote control includes an accelerometer. If it is shaken, it triggers the execution of a nominal cycle, and therefore transmission of
SIGFOX frames.
Stage
ON Position
Meaning
Wake up of the GPS pending synchronisation
When GPS is synchronised, LED 2 switches to continuous
orange.
If the GPS is not synchronised, the LED remains on continuous
red.
A SIGFOX message is being sent, with 2 repeats
Reception window, waiting for a response from the SIGFOX
server
The response has been received. The OOB frame is sent
The cycle finished correctly. The response received from the
server is output on the Demonstrator's serial link.
Page
6
of 9
Advertisement
Table of Contents
