Wolf e Series Installation Instructions Manual page 17

I N S TA L L AT I O N I N S T R U C T I O N S
E L E C T R I C A L R E Q U I R E M E N T S
With the oven positioned directly in front of
the cabinet opening, feed the properly rated
cord attached to the oven terminal box
through the opening in the cabinet platform
(where applicable). Then, depending upon
local codes, utilize one of the following tech-
niques to connect the appliance to the electri-
cal power supply.
I N S TA L L I N G T H E O V E N
U N P A C K T H E O V E N
Oven is not mounted to the shipping
base. Do not remove banding until the
oven is at the point of installation.
Cut the plastic straps and remove the two
V-boards. Remove the four top foam corners
and the corner posts. Remove the carton
sleeve by lifting the sleeve up and over the
appliance.
Remove all oven racks, oven rack guides and
broiler pan from inside the oven cavity. For the
double oven, be sure to do this for both the
upper and lower ovens.
Remove the four bottom corners. Use caution
as the oven is not mounted to the shipping
base. Keep the bottom foam in place when
moving or carting the oven. The bottom foam
also protects the factory-installed trim.
Do not remove the bottom foam until
oven has been positioned next to the
installation opening.
IMPORTANT NOTE: Before moving the oven,
protect any finished flooring with appropriate
materials to avoid damage to the floor.
Remove and discard all packing materials,
including cardboard and tape on the outside of
the oven and inside the oven cavity.
Do not lift the unit by the oven door
handle(s). This will damage the oven door
and hinges.
17