Coopers of Stortford F332 Instructions For Use

Airbed with Motor
Please read and retain these instructions for future reference
INSTRUCTIONS FOR USE:

Inflation

1. Move the airbed to the power source location.
2. Plug in the plug into a mains socket.
3. Turn the control dial clockwise until arrow points to the inflate symbol to inflate.
4. When the airbed is fully inflated to the desired firmness, turn dial to the "OFF" setting.
5. Lie down on the airbed to test the firmness.
6. If the sleeping surface is too hard, adjust the firmness by turning the control dial counter-counter
clockwise gradually until air starts to exit through the air passage (see Fig. 1). Turn the control dial to the
"OFF" position when the desired firmness is achieved (see Fig 2). If the airbed becomes too soft repeat
step 3 to step 6 as necessary.
7. Disconnect the power cable from the mains socket, place it inside the cord compartment and close the
cover.
Important Note
Proper inflation of the airbed.
The ambient temperature of the air has an effect on the airbed's internal pressure. At low ambient
temperature the air will contract within the airbed and the airbed will feel softer: add air as necessary. At
high ambient temperature the air within the airbed will expand significantly and the airbed will become hard
and may burst; release air to avoid damage to the airbed or to soften the feel. Do not expose the airbed to
extreme temperatures (hot or cold).
Stretching is a natural characteristic of new vinyl. During initial use, the airbed may become soft and require
F332

Dimensions:

208cm x135cm x46cm
Weight: 11kg
Max. weight capacity: 300kg
Length of power lead: 130cm
Power details:
220-240V AC, 50Hz, 120W
Fig. 1
Instructions for Use
v002: 16/08/19
Fig. 2
F