Battery Tool Use And Care; Service; Electrical Safety; Labels On Tool - Black & Decker GC1200 Instruction Manual

ENGLISH
e. Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and any
other condition that may affect the power tools
operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly
maintained power tools.
f. Use the power tool, accessories and tool bits etc.,
in accordance with these instructions, taking into
account the working conditions and the work to be
performed. Use of the power tool for operations different
from those intended could result in a hazardous situation.

5. Battery tool use and care

a. Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
b. Use power tools only with specifically designated
battery packs. Use of any other battery packs may create
a risk of injury and fire.
c. When battery pack is not in use, keep it away from
other metal objects, like paper clips, coins, keys,
nails, screws, or other small metal objects, that can
make a connection from one terminal to another.
Shorting the battery terminals together may cause burns
or a fire.
d. Under abusive conditions, liquid may be ejected from
the battery; avoid contact. If contact accidentally
occurs, flush with water. If liquid contacts eyes,
additionally seek medical help. Liquid ejected from the
battery may cause irritation or burns.

6. Service

a. Have your power tool serviced by a qualified repair
person using only identical replacement parts. This will
ensure that the safety of the power tool is maintained.

7. Electrical Safety

Your charger is double insulated; therefore no earth
wire is required. Always check that the mains
voltage corresponds to the voltage on the rating
plate. Never attempt to replace the charger unit with
a regular mains plug.
Warning! If the power cord is damaged, it must be
replaced by the manufacturer, authorized Black &
Decker Service Center or an equally qualified person
in order to avoid damage or injury. If the power cord
is replaced by an equally qualified person, but not
authorized by Black & Decker, the warranty will
not be valid.
14

8. Labels on Tool

The label on your tool may include the following symbols:
Read Instruction Manual
Use Eye Protection
Use Ear Protection
V..................................... Volts
A..................................... Amperes
Hz................................... Hertz
W.................................... Watts
min.................................minutes
.................................. Alternating current
.............................. Direct current
n .................................... No load speed
0
.................................. Class II Construction
.................................. Earthing terminal
.................................. Safety alert symbol
.../min............................. Revolutions or reciprocations
per minute