Operating The Machine; Machine Movement - Rg27/35; Steer Right/Left; Machine Movement - Rg37 - Rayco Super Jr RG27 Operator, Service, Maintenance Manual

RG27/35/37 Operation • Service • Maintenance
Operation

Operating the Machine

Machine Movement - RG27/35

5
6
1

Machine Movement - RG37

7
8
6
5
1
Move Forward/Reverse
(1) Move machine Towards/Away from stump with lever
28
2 3 4
9
3
4
2

Steer Right/Left

(2) Steer machine Left/Right with lever
(3) Blade/Boom Movement - Raise and Lower
The control levers will re-center themselves
a neutral position when released. No movement
10
should occur, if you observe any movement when
controls are in nuetral position, please contact
a service technician immediately and follow the
tag-out procedure outlined in the safety section of
this manual.
(4) Cutter Boom Swing - Left or Right
(5) Blade/Boom Switch - select which tool attachment the
levers will control.
(6) Engine Throttle
(7) Engine Oil Pressure Warning - If this light illuminates,
the engine will shut down. Service engine immediately.
(RG37 Only)
(8) Engine Warning - If this light illuminates, the engine will
shut down. Check engine manual for troubleshooting
and service engine immediately. (RG37 Only)
10
(9) Emergency Shut Down (RG37Only)
ROTATION DOES NOT STOP INSTANTLY. A
ROTATING CUTTING WHEEL IS VERY DANGEROUS!
STAND AT THE CONTROLS AND WATCH THE
CUTTING WHEEL UNTIL COMES TO A COMPLETE
STOP BEFORE DOING ANYTHING ELSE
(10) Cutter Wheel On/Off. - Pull the switch up after the
engine is running and the safety tether is lowered in its
correct position.
NOTE: The cutter wheel will not engage if the safety tether
THE OPERATOR SHOULD NEVER ATTEMPT TO
7 LEAVE THE OPERATOR STATION WHILE THE
CUTTER WHEEL IS ENGANGED.
is not in its proper location.
NOTICE
in