Wavemaster BASE User Manual

Dear User,
we are pleased that you have chosen the BASE loudspeaker system from wavemaster and
congratulate you on this choice.
With this wavemaster BASE you have acquired a modern piece of audio technology that is in equal
measure attractive and of high quality. We are sure that this product will provide useful service and a
lot of fun to you over the coming years.
... Your wavemaster Team!

After unpacking

After unpacking you should first check that the contents are complete. In addition to this instruction
manual there should be:
2 speaker boxes
1 Speaker cable with stripped ends
1 Audio adaptor cable 3.5 mm stereo mini phono plug -> 2x RCA (Cinch) plug

Advice on location, care and safety

Connect the audio input to the line-out, non amplified output. Avoid connection to the speaker-out
•
jack of your sound source. The amplified signal from the speaker-out may cause unnecessary
distortion and may damage the speaker-circuit.
To connect your sound-system with power supply system, please make sure to have a mains socket
•
close to your sound-system.
If the sound-system is not in use for a longer period of time, be sure that your system is
•
disconnected from mains power.
Do not use alcohol, benzene, thinner or acids to clean the cabinet.
•
Do not place your sound-system near radiators, airconditioning or radio-controlled systems.
•
Avoid leaving the sound-system in permanent strain such as direct sunlight, extreme moist or
•
dryness, exceptional cold or heat, mechanical vibrations or shock.
Do not open the cabinet, contact qualified personnel only.
•
For service staff: Never open cabinet, when speaker system is connected to 110-240 V AC
•
power supply system.
CAUTION!! Power ON / STANDBY switch does not separate mains power!
•
Deliberate harm to the equipment is not covered by the guarantee.
•
Please contact your dealer in case of technical problems.
•
User Manual
1