Troubleshooting - Gigaset Repeater HX Manual

Miscellaneous
Reset repeater
If registration was not successful or re-registration has to be carried out for another reason, you
can reset the repeater as follows.
¤
Press repeater button (left LED flashes slowly).
¤
Release repeater button once the left LED flashes quickly (after approximately 10 seconds).
The repeater is ready for registration once again.
Check the accessibility of a handset using a verification tone
The verification tone enables you to establish whether or not the handset is working in the
extended area, see page 5 of the Gigaset Repeater. This tone is audible on the handset every 2.5
seconds as long as a line is allocated.
Proceed as follows:
¤
Repeater: To switch on the verification tone:
Press repeater button until the right LED lights up (after approximately
20 seconds).
¤
To switch off the verification tone again:
Press repeater button again until the right LED goes out (after approximately
20 seconds).
¤
Handset: Allocate line (hold down call answer button).
¤
When you hear the verification tone, you are in the extended reception area.
If you don't hear a verification tone, move towards the repeater with the
handset until you hear it.
Miscellaneous

Troubleshooting

Problem
Left LED flashes continu-
ously when the registration
procedure has been con-
cluded
Left LED flashes continu-
ously at a selected location
Left LED does not light up at
all
6
Cause
No radio connection to
the base station
No radio connection to
the base station
Power supply off
Action
Repeat registration
Select a new location
Check the power point