Related Manuals for Victrola ITCDS-5001
Summary of Contents for Victrola ITCDS-5001
- Page 1 Bluetooth CD Stereo System Model: ITCDS-5001 Instruction Manual PLEASE READ THIS INSTRUCTION MANUAL CAREFULLY BEFORE USE AND KEEP IT FOR FUTURE REFERENCE.
-
Page 2: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Invisible and hazardous laser radiation when open and interlock failed or Defeated. Avoid direct exposure to beam. a tabletop, etc., or where it can be pulled on by children or tripped over accidentally. FCC Warnning: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. - Page 3 Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to operate this equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
-
Page 6: Product Overview
PRODUCT OVERVIEW FRONT VIEW POWER FUNCTION SCAN TUN- TUN+ AUX IN VOLUME BALANCE BASS TREBLE 11 12 13 14 15 16 17 18 1 & 2. VU Meters 12. Volume Button 13. Previous Button CD Drawer 14. Balance Control Knob Open/Close Button 15. -
Page 7: Rear View
REAR VIEW SPEAKER OUTPUT DC 12V 2A FM ANT. 22. FM Antenna 23. Speaker Output Connectors 24. DC IN Jack EXTERNAL SPEAKER 25. External Speaker Connectors... -
Page 8: Remote Control
REMOTE CONTROL FUNC PROG. REPEAT BALANCE TREBLE BASS TUN- SCAN TUN+ 1. Power ON/OFF Button 12. Scan Button 2. Function Button 13. Tune Down Button 3. Random Play Button 14. Open/Close Button 4. Treble Up Button 15. Repeat Button 5. Right Balance Button 16. -
Page 9: Remote Control Battery Installation
REMOTE CONTROL BATTERY INSTALLATION FIRST TIME USE Remove and discard the insulation film as shown on Fig. 1. BUTTON CELL REPLACEMENT Fig.1 1. Push and slide out the battery holder as shown on Fig.2. 2. Replace the battery with a new CR2025 button cell as the polarity R2025 marking facing upward as shown on Fig.3. -
Page 10: General Operation
GENERAL OPERATION 1. Connect the external speakers by connecting the respective R & L wires on the back of the unit. Note: Make sure the cables are connected firmly. If there is no sound, please reconnect. Make sure the red cable is connected to the red connector, and the red-black cable is connected to the black connector. -
Page 11: Fm Radio Operation
FM RADIO OPERATION 1. Press the FUNCTION button on the unit or the FUNC button on the remote control to switch to FM mode, the FM frequency will appear on the display. 2. Press and hold TUN- or TUN+ to search automatically until a station is found, and it will play automatically. -
Page 12: Aux-In Operation
2. Turn on Bluetooth on your external Bluetooth device and open your device’s Bluetooth Setting Menu. 3. Select "ITCDS-5001" from the pairing list to connect to the unit. 4. Once your device is connected successfully, "BLUE" will stop blinking on the display. -
Page 13: Care And Maintenance
CARE AND MAINTENANCE Caring for Discs Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to touch the shiny, unprinted side of the disc. ● Do not attach adhesive tape, stickers, etc. to the disc label. ●... -
Page 14: Troubleshooting Guide
TROUBLESHOOTING GUIDE SYMPTOM POSSIBLE CAUSE POSSIBLE SOLUTION No power. The adapter is not connected. Connect the adapter to the unit to a wall outlet. The unit is off. Press the button to power on the unit. Volume level is too low. Raise the volume level by rotating the No sound or volume knob on the unit or press the... -
Page 15: Specifications
SPECIFICATIONS AMPLIFIER Output Power ..................10W+10W Frequency Response ..............60 to 20,000 Hz TUNER Frequency Range ................87.5- 108.0 MHz CD PLAYER Frequency Response ..............60 to 20,000 Hz Signal-to-Noise Ratio ................. 55dB (IEC-A) Compatible Disc ................ CD, CD-R, CD-RW SPEAKER SYSTEM Impedance.................... - Page 16 God or attempted repair by an unauthorized service agent. To obtain service, the purchaser MUST present an original sales receipt / proof of purchase. Please contact us at www.victrola.com to request an RMA (Return Material Authorization) number to return products for service or replacement.