Honeywell 400 Series Hardware Manual page 69

CONTRO L/INDICATOR
POWER OFF pushbutton
OPERATE/RESET pushbutton and
indicators (green/blue)
HALT pushbutton and indicator (blue)
MANUAL CYCLE/ FEED pushbutton
and indicator (blue/ red)
FUNCTIONS
1. Empty input hopper
2. Full output stacker
3. ' Manual halt initiated by the operator
4. Chad box too full or incorrectly posi-
tioned
5. Feed alert
6. Card jam
7. Empty prepunch station
8. Reject pocket full
9. Cards fed to wrong stacker
NOTE: When control is actuated, and sub-
system reverts to the operate condition, a
Special Interrupt signal is sent to the pro-
cessing system.
Pressing the control during operation stops
punching and feeding when the current card
is completely punched.
When the cause of the halt is corrected and
OPERATE/RESET is pressed, the HALT light
goes off.
If the light is not on, briefly pressing the
switch once causes a card to move from the
input hopper into station 1; all cards in the
track advance to the next station. If the
switch is held down when the light is not
-60-