Advertisement
Assembly
Assembly: Rollbar and side parts (Fig. 4)
Unfold the side parts of the included main section in an outwards direction, and stand the
1a
rollbar up in a vertical position. Now insert the threaded bolts into the holes on both sides
of the handle, and fasten these tightly with the included fastening nuts «S».
1b
Now, on the front face, snap the floor cover to the fastening knobs using the rubber rings.
Mounting the wheels
From below, slide the wheels up into the axle holders, tighten the quick tighteners, and
2
when they are tight enough, turn them down.
Note:
Locking brake
The locking brakes at the back can be engaged and disengaged by foot.
Fig. 5
3
Advertisement
