Page 5
Max. payload 45 kg. Additional equipment A wide range of accessory parts are available for the Leggero Vento. Ask your dealer, or enquire directly at the manufacturer about the available accessories, or request an up- to-date list.
• Use of the trailer with a motor vehicle – except for mopeds up to a maximum speed of 25 kph – is prohibited. • The Leggero Vento may be coupled to the bicycle only using the included coup- ling.
Page 8
Adjusting the safety belts The safety belts should pass horizontally or angled slightly upwards (max. 15°) over the shoulders of the child to provide the best possible safety. 0˚–15˚ To achieve this, the belts can be adjusted. To do this, slide the belts towards the back through the slits in the tray. From the back, slide the belts again towards the inside through other slits.
Page 9
Included in the delivery (Fig. 3) Model Leggero Vento trailer for pulling children Name Quantity Main section, including 2 seats Wheels Cover v 98 Tow bar with «becco» coupling Flag «becco» coupling Operating instructions Assembly materials Name Quantity Fastening nuts «S»...
Page 10
Assembly Assembly: Rollbar and side parts (Fig. 4) Unfold the side parts of the included main section in an outwards direction, and stand the rollbar up in a vertical position. Now insert the threaded bolts into the holes on both sides of the handle, and fasten these tightly with the included fastening nuts «S».
Page 11
Front Fig. 4 Locking brake open closed Rear...
Page 12
Mounting the seats (Fig. 5) On the left side insert the seating tube into the hole of the wheel holder intended for this. Now, by pulling back the pin, on the right side it is possible to clip the seating tube into the hole for this in the wheel holder housing.
Page 14
Mounting the tow bar (Fig. 6a) Now insert the tow bar into the holder intended for this. To do this, slide out the tow bar knob and let it snap in again in the desired position. These positions are possible: •...
Page 15
Riding position Walking position Fig. 6a 29 Inches 26 Inches 6 Inches 10.50399.0020/02.10 Fig. 6b...
Page 18
Hitching and unhitching (Fig. 10–18) Hitching Open the coupling lever. Using the thumb, push up the shorter lever and flip over for- wards fully. Slide the coupling sideways over the pulling part on the coupling plate. Close the coupling. Flip the longer lever over towards the back, and then press down until the coupling latches in.
Unhitching Maintenance and care Material; white: • The colour of the material changes over time. It may be that it darkens slightly. • We exclusively use non-toxic materials to manufacture the textile parts. Our textiles are anti-toxic, treated to resist fungus growth and dirt repellent. Maintenance: All links and moveable parts are maintenance free.
Safety check-list Before using your trailer for the first time, please re-read the general safety precauti- ons in the first section. Every time you use the trailer, check the following before doing so: • Are the wheels properly and securely attached? •...
Page 21
Factors which have the effect of increasing wear...