Connection To The Pipework System; Operation - YAMADA HR Series Instruction

2.3 Connection to the pipework system

Install a stop valve on the pipe system before connecting the hose.
1) Attach the ring on the arm. (Fig.13)
2) Pass the intake hose through the ring and connect it to the pipe
work.
Use the provided hose fitting if necessary. (See Table 1)
3) Check that the intake hose is not twisted or strained after
connection.
■Table 1
Product No. Description
N831488
Hose Reel
N832888
888
N831888
854671
Hose Reel
N830889
889
N831689

3. Operation

The hose reel is delivered with a ratchet mechanism which retains the
hose in the required outdrawn position. (Fig.14)
The ratchet will disengage if the hose is drawn out a little further and the
hose then recoils to the drum. It should be noted that the hose should be
held by the hand as long as possible during the recoiling.
- When pulling out the supply hose, always hold the hose and pull it out straight. The hose may be
damaged if excessive force is applied to the hose fittings.
- Do not let go of the hose when rewinding to prevent it from being wound vigorously onto the drum.
- You may burn your hand by friction if you allow the hose to retract vigorously, holding it.
- Use Pivoting wall bracket (optional extra: N372407, N372408) if you want to pull the hose to the side.
- Do not pull out or wind up the supply hose vigorously. Rough handling may affect the function of each
part or cause product malfunction or damage to the hose.
Model Application
HR-3G10 Oil
HR-3C15 Grease
HR-3WH15 Warm Water
HR-4A15 Air
HR-4W15 Water
HR-4G15 Oil
CAUTION
(Fig.13)
Hose Size Outlet
Part No.
1/2 × 1m G1/2 686455
680140
3/8 × 1m G3/8
684517
3/8 × 1m G3/8 685919
1/2 × 1m R1/2 686452
1/2 × 1m R1/2 686454
1/2 × 1m G1/2 681785
Fig.14 ratchet mechanism
4
Intake Hose
Fitting (accessory)
Description
Male fitting
Male fitting
Male fitting
Male fitting
Union Adapter Rc1/2 - G1/2
Male fitting
Male fitting
Fig.13
Size
G1/2- R3/8
G3/8- R3/8
G3/8- G1/4
G3/8- R3/8
G1/2 - R1/2
G1/2 - R1/2