Table of Contents
Advertisement
WLAN/Bluetooth combo card
The computer uses a card that provides both WLAN and Bluetooth functionality.
Description
Intel Dual Band Wireless-AC 8265, 802.11ac, 2×2 Wi-Fi + Bluetooth 4.2 combination adapter (non-vPro)
Before removing the WLAN module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Place the computer in "Battery Safe mode"
3.
Disconnect all external devices connected to the computer.
4.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
5.
Remove the main service door
Remove the WLAN module:
1.
Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2". If the
computer is equipped with an 802.11a/b/g/n WLAN module, the yellow WLAN antenna cable connects to
the middle terminal on the WLAN module.
2.
Remove the Phillips M2.0×4.0 screw (2) that secures the WLAN module to the computer. (The edge of
the module opposite the slot rises away from the computer.)
30
Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
(Service doors on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
(Battery Safe mode on page
26).
Spare part number
851594-001
25).
Advertisement
Table of Contents
