Since Bardimm 1.8E: Modified Id For Code 128C - Jetmobile BarDIMM Pro Installation And Programmer's Manual

BarDIMM Pro & BarDIMM Box – Intelligent

Since BarDIMM 1.8E: modified ID for Code 128C

BarDIMM 1.8E and next versions have a minor modification compared to previous
versions. Code 128C used to have an ID of 24703. Due to a new font numbering system
starting with the HP LaserJet 4000, Code 128C needed to be moved from ID 24703 to ID
24704. The obsolete ID (24703) is not be supported on HP LaserJet/Business Ink Jet
printers released after September 1997 and starting with the HP LaserJet 4000. The
obsolete ID will still be supported on printers released before October 1997, for backward
compatibility purpose. If you are already using the BarDIMM with Code 128C, we
recommend you change it for the Code 128 Autoswitch ID. The resulting barcodes will be
the same (Code 128C), as BarDIMM will detect data for Code 128C.
If you are not using the old Code 128C barcode ID, that modification will not affect
your application.
Important note: Should you need to upgrade your printer firmware:
• Uninstall BarDIMM (Switch off and unplug all cables from your printer/MFP,
remove the BarDIMM DIMM, CompactFlash or USB then plug back all cables and
switch on the printer)
• Perform the firmware upgrade and verify the success through the configuration page
• Reinstall the BarDIMM module inside the printer
Not following that procedure may lock your printer and require direct hp
support
Page 18
Barcode Printing System
www.jetmobile.com ©2004-2006 Jetmobile