Related Manuals for Lakes SS20
Summary of Contents for Lakes SS20
- Page 1 TWIN PANEL BATHSCREENS Installation & Maintenance Instructions rev 01.19 Models Covered : SS20 : CURVED SCREEN SS40 : SCULPTED SCREEN SS60 : SQUARE SCREEN SS22 : CURVED SCREEN SS44 : SCULPTED SCREEN SS66 : SQUARE SCREEN + TOWEL RAIL + TOWEL RAIL...
-
Page 2: Important Notes
However should maintenance be required it should be carried out by a competent person with reference to these instructions. Before any work is carried out the root cause of the problem must be identified. Lakes Bathrooms service engineers are available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE. -
Page 3: Supplied Parts
SUPPLIED PARTS : Fixed Screen Sub Assembly Moving Screen Sub Assembly Comprising: Comprising: Wall Rail fig A Hinge Rail Vertical Rail (bonded to (bonded to screen glass) screen glass) Top Plug (Vert Rail) fig B Hinge Half Hinge Rail (female) (bonded to (2x) screen glass) - Page 4 The use of good quality silicone sealant & cleaning / degreasing of all joint areas is recommended. Lakes fully reversible Single Panel Bathscreen for fitting left or right handed to suitable bathtub. Ensure bath rim is level & that bath / wall (tile) joints are sealed & cured over entire length of bath sides (See Fig A) prior to fitting screen.
- Page 5 Sleeve Sub assembly of Fixed Panel Hinge seal ** Ensure that ‘Hinge Seal’ ** is toward bathtub (WET) side of screen. Hinge half (male) Having determined panel orientation, fit top & bottom plugs to vertical rail Bottom seal (fixed panel) Slide hinge seal into groove of hinge rail &...
- Page 6 Loosen clamping screw, & fit bracing arm over glass as shown, position bar such that wall end sits flush onto tiled wall. Mark hole position, drill (dia 8mm), plug & affix bracing arm to wall. Ensure gasket & screw pad are against glass faces &...
- Page 7 Note : Towel Rail used on S Towel Rail Models Sleeve a different style (straight bar), Decorative but is affixed in the same way. Rubber Washer Washer Screw Towel Rail Internal Boss Rubber Washer A) Tighten screw fully into internal boss. B) Fit rubber washer &...
-
Page 8: Basic Troubleshooting
/ bottom hinge ONLY. Water / moisture appearing outside this area (ie under the bathtub or at floor level) is normally due to incorrect bathtub installation / sealing. Lakes Bathrooms Ltd Lakes Bathrooms Ltd Service : Northern Ireland...