Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Ubiquiti Unifi ULED-AC
Summary of Contents for Ubiquiti Unifi ULED-AC
- Page 1 Network-Managed LED Panel Powered by AC Model: ULED-AC...
-
Page 2: Package Contents
Introduction Thank you for purchasing the Ubiquiti Networks® UniFi® LED Panel. This Quick Start Guide is designed to guide you through installation and includes warranty terms. Package Contents Network-Managed LED Panel Powered by AC Model: ULED-AC UniFi LED Panel Quick Start Guide System Requirements •... -
Page 3: Installation Requirements
Installation Requirements • Phillips screwdriver • Wire stripper/cutter • Needle-nose pliers (Optional) IMPORTANT: The ULED-AC is to be installed by a qualified electrician in accordance with local electrical codes and regulations. IMPORTANT : Le ULED-AC doit être installé par un électricien qualifié conformément aux codes électriques locaux et des règlements. -
Page 4: Network Topology Requirements
Network Topology Requirements Network topology requirements are as follows: • DHCP-enabled network (for the UniFi LED Panel to obtain an IP address) • Network switch (for wired configuration), or access point (for wireless configuration) • For UniFi Dimmer Switch only: A UniFi Dimmer Switch connected to the same Layer 2 network as the UniFi LED Panel •... - Page 5 100-277VAC UAP-AC-PRO ULED-AC 100-277VAC 802.3af PoE UniFi LED UDIM-AT UDIM-AC UniFi PoE Switch UniFi LED Controller UniFi Application Server USG-PRO-4 (DHCP Server) Internet Sample Network Diagram - Wireless Topology...
- Page 6 ULED-AC Ethernet 100-277VAC UAP-AC-PRO 802.3af PoE UDIM-AT UniFi LED UniFi LED UniFi PoE Switch Controller UniFi Application Server USG-PRO-4 (DHCP Server) Internet Sample Network Diagram - Wired Topology...
-
Page 7: Daisy-Chain Configuration
Daisy-Chain Configuration For installations using multiple UniFi LED Panels in a wired configuration, we recommend using a daisy chain topology, as illustrated in the following diagram. (Additional LED Panels) 100-277VAC Ethernet ULED-AC 100-277VAC Ethernet ULED-AC 802.3af PoE UDIM-AT UniFi PoE Switch UniFi LED Controller UniFi Application Server... -
Page 8: Hardware Overview
Hardware Overview Status LED ULED-AC-XXXXXX State Status Flashing White Initializing. Steady White System ready. Steady Blue Adopted by LED Controller. Alternating Firmware upgrade is taking place. White/Blue Ports MAC Sticker Ethernet ULED-AC-XXXXXX Ethernet Use these 10/100 Ethernet ports to connect to the LAN or to daisy-chain with other UniFi LED Panels. -
Page 9: Terminal Block
Button Reset ULED-AC-XXXXXX Reset The Reset button serves two functions: • Restart Press and release the Reset button quickly. • Restore to Factory Default Settings Press and hold the Reset button for more than five seconds. Terminal Block Connections for AC power: N (Neutral), L (Live), and (Earth ground). -
Page 10: Installation
Installation To install and configure the UniFi LED Panel: 1. Lift the panel and seat it in an opening in the ceiling grid. 2. If the panel will use Wi-Fi to connect to the network, go to step 3. If the panel will use a wired connection to the network, connect an Ethernet cable to the Main port. - Page 11 4. Remove a knockout from the Junction Box and feed the power cable through the knockout into the Junction Box. 5. Connect each of the cable’s wires to the appropriate Terminal Block connector as follows: • Connect the Neutral (white) wire to N. •...
- Page 12 Daisy Chain Configuration (Optional) For each additional panel in the chain: 1. Make the following changes to the UniFi LED Panel which is currently the last panel in the chain: a. If the new panel will use a wired connection to the network, connect an Ethernet cable to the Secondary port of the current last UniFi LED Panel.
- Page 13 Configuring the UniFi LED Panel Follow the instructions for the software you wish to use: UniFi LED App 1. Install the UniFi LED app on your smartphone or mobile device. The app is available from the App Store® or Google Play Store.
- Page 14 UniFi LED Controller Software 1. Install the latest version of the UniFi LED Controller software on a computer on the same Layer 2 network as the UniFi LED Panel: • Ubuntu users Download the software from: www.ubnt.com/download/unifi-led UAS users • Install the software using the UniFi Application Server (UAS) management console.
-
Page 15: Quick Setup
Quick Setup This section describes the Quick Setup procedure for installations with large numbers of UniFi LED Panels and Dimmer Switches. The Quick Setup requires using the UniFi LED app along with a QR Code Log that you create. Each UniFi LED Panel or Dimmer Switch has a removable MAC Sticker on its reverse side;... - Page 16 Install the LED Panels and Dimmer Switches For each UniFi LED Panel or Dimmer Switch: 1. Remove the MAC Sticker from the back of the device by carefully peeling back and pulling the blue tab. 2. Place the sticker on the QR Code Log sheet that matches the device’s location.
- Page 17 Scan the QR Codes 1. On your mobile device, open the UniFi LED app. 2. Go to the More screen. Tap Quick Setup. 3. Follow the instructions as the UniFi LED app guides you through the process of adding devices by scanning the QR codes on the QR Code Log sheet(s).
-
Page 18: Specifications
Specifications ULED-AC Dimensions 602 x 602 x 56.7 mm (23.7 x 23.7 x 2.23") Weight 5.3 kg (11.68 lb) Networking Interface 802.11 b/g/n (2.4 GHz Only) 10/100 Ethernet Port Wireless Security WEP, WPA/WPA2 Personal Connectivity Wi-Fi 802.11 b/g/n, Bluetooth LE 4.1 Buttons Reset LEDs... -
Page 19: Safety Notices
UniFi LED Panel AC (the “LED Product”) only. All other UBIQUITI products are covered under the limited warranty found at: ubnt.com/support/warranty. It is UBIQUITI’S policy to offer a limited product warranty to end users of the LED Product (the “customer” or “you”) only on LED Products purchased from an authorized UBIQUITI distributor or reseller and only accompanied by a Return Materials Authorization (“RMA”) as further described below. -
Page 20: Limited Product Warranty
UBIQUITI warrants that the LED Product shall be free from defects in material and workmanship for a period of five (5) years from the date of shipment by UBIQUITI under normal use and operation. UBIQUITI’S sole and exclusive obligation and... - Page 21 (XIII) or the customer has not followed local country regulations, including operation within legal frequency channels, output power Dynamic Frequency Selection requirements; or (XIV) has not been received by UBIQUITI within 90 days of issuance of the RMA. Returns and Product Replacement No LED Products will be accepted for replacement without obtaining an RMA number from UBIQUITI during the warranty period.
-
Page 22: Limitation Of Liability
OF PROFITS, LOSS OF USE, CONTENT CORRUPTION, PACKET LOSS, OR OTHER DAMAGE RESULTING FROM ANY OF THE FOREGOING INCLUDING ACTS OF GOD. In addition, UBIQUITI does not warrant that the operation of the Products will be error-free or that operation will be uninterrupted. In no event shall UBIQUITI be responsible for damages or claims of any nature or description relating to system performance, including coverage, customer’s selection of products (including... - Page 23 Please visit http://www.iccwbo.org for more information. How to Opt Out of Mandatory Arbitration. Notwithstanding the above, you or UBIQUITI may choose to file a lawsuit in court rather than resolving your Dispute with UBIQUITI by arbitration. You may opt-out of mandatory...
- Page 24 It is to be sent to the address listed at (I) in the above paragraph. If UBIQUITI does not resolve the dispute within forty-five (45) days you may pursue your dispute in arbitration. You may pursue your dispute in a court only under the circumstances described above in the Opt Out provision.
- Page 25 (30) days in the interests of justice upon written notice by the arbitrator to You and UBIQUITI at least twenty-one (21) days prior to the last date to issue his or her decision. Failure to adhere to this time limit shall not constitute a basis for challenging the arbitration award.
- Page 26 Jury Waiver. You understand and agree that by failing to opt out to this provision you and UBIQUITI are each waiving the right to a jury trial or a trial before a judge in public court. In the absence of this provision, you and...
- Page 27 You may have other rights that vary from country to country, state to state, or province to province. EXCEPT TO THE EXTENT ALLOWED BY LOCAL LAW, THESE WARRANTY TERMS DO NOT EXCLUDE, RESTRICT OR MODIFY, AND ARE IN ADDITION TO, THE MANDATORY STATUTORY RIGHTS YOU MAY HAVE. FOR A FULL UNDERSTANDING OF YOUR RIGHTS YOU SHOULD CONSULT THE LAWS OF YOUR STATE, PROVINCE, OR COUNTRY.
-
Page 28: Online Resources
New York, NY 10017 ©2019 Ubiquiti Networks, Inc. All rights reserved. Ubiquiti, Ubiquiti Networks, the Ubiquiti U logo, the Ubiquiti beam logo, and UniFi are trademarks or registered trademarks of Ubiquiti Networks, Inc. in the United States and in other countries. Apple and the Apple logo are trademarks of Apple Inc., registered in the U.S.