Quick Set-Up Guide - Killgerm Motion Sensor Camera Instruction Manual

MOTION SENSOR CAMERA INSTRUCTION MANUAL
2. Quick guide set-up
The below steps are a brief instruction in setting up your camera to help you get
started. However, we would advise you read this whole document to set up your
camera fully, especially if you are utilising the text/email functionally provided:
Step 1: Open-up the camera and insert the x8 AA batteries and Micro SD Card into
their specific slots.
Step 2: Switch the camera into "TEST" Mode and press the "MENU" button and set
the appropriate camera/video setting to suit you.
Step 3: Switch the camera into "ON" Mode and set in position ready to trigger. This
will give you approximately 10 seconds to evacuate the area while a red light
will blinks before setting into action.
Steps 1 to 3 will allow you to use the camera as a traditional motion sensor
camera. If you require the text/email functionality then continue with steps 4 to 6.
Step 4: Download Software and insert/test SIM, credit. (See point 2, Page 12)
Step 5: Load up software and the pre-set network settings, insert your personal details
eg. phone number / email.
Step 6: Save the settings as the Parameter.dat file on the Micro SD Card. Then switch
the camera into "ON" Mode and set in position ready to trigger. Finally text
the command *505* to the Sim card number in the camera to activate.
4