Table of Contents
Advertisement
Assembly and Installation Instructions
1. By hand, unscrew the entire Fleck 2510 control valve from the top of the tank (if it was shipped
screwed on). If not already done, make sure the blue cap is on top of distributor tube, or wrap the
top of distributor tube with electrical or duct tape. You do not want Calcite to go down the
distributor tube.
2. Next, add Calcite or Calcite-blend media. If you are using a blend of Calcite and Corosex, make sure
to read page 11 for more information on using and adding blends.
3. Remove cap or tape from the top of distributor tube. Be careful not to pull up the distributor tube
when removing cap or tape.
4. If possible at this point, fill tank completely with water. This will allow the neutralizer media to settle
and eliminate the need for purging air out of the tank later.
5. Next, insert the top distributor basket into the bottom of the Fleck 2510 control valve and rotate
clockwise (see Fig 3.). This will keep the media from moving into the head during backwash.
6. Do not use pipe-joint compound, Teflon tape, Vaseline or other petroleum greases to lubricate tank
threads. Do not over-tighten when threading Fleck 2510 control valve on to tank. Do not allow hard
piping to cause stress on the Fleck 2510 valve, the pipes should not be pulling down or up on the
valve. Flexible connectors avoid this problem and are recommended.
Fig 3 - Top Distributor Basket
Page 6
Fleck 2510 Neutralizer Installation & Startup Guide
www.cleanwaterstore.com
Rev 062714
Advertisement
Table of Contents
