Pioneer DJM-909 Training Manual page 20

5. Calibration mode for the touch panel
To enter this mode, press the CH1 FADER CURVE/ BANK EDIT button during Setup mode. (For details on how to enter Setup mode, see
"3. Setup mode.")
Calibration Mode : ON
CH1 FADER CURVE
/ BANK EDIT
• When Calibration mode for the touch panel is activated, "DJM-909 CALIBRATION" is displayed at the upper center of the LCD, and "TAP"
and an arrow are displayed at the lower right.
How to set up
1 Tap on the tip of the arrow at the lower left of the LCD with a pointed object.
2 When "TAP" and an arrow are displayed at the upper right of the LCD, tap on the tip of the arrow with the pointed object.
6. Factory-preset effect mode
To enter this mode, press the CH2 FX ADJ. button during Setup mode. (For details on how to enter Setup mode, see "3. Setup mode.")
Efect Mode : ON
CH2 FX ADJ.
• When Factory-Preset Effect mode is activated, "DJM-909 RESET" is displayed at the upper center of the LCD, and "ARE YOU SURE" is
displayed at the lower center.
How to reset to factory-preset values
1 Press the CH1 FADER CURVE/ BANK EDIT button.
7. Version Check mode
• You can check the software version of each microcomputer.
Version Mode : ON
CH1TAP CH2TAP
• In normal operation mode, press the CH1 TAP and CH2 TAP buttons simultaneously and hold them pressed for 10 seconds.
The software version of each microcomputer is displayed on the LCD.
• To quit this mode, press any of the CH1 BANK1, CH1 BANK2, CH1 BANK3, CH2 BANK1, CH2 BANK2, CH2 BANK3, CH1 FX ADJ.,
CH1 FADER CURVE/ BANK EDIT, CH2 FX ADJ., or CH2 FADER CURVE/ BANK EDIT buttons.
DJM-909
CALIBRATION
TAP
TO MENU
DJM-909
RESET
ARE YOU SURE
YES
TO MENU
SERVICE MODE
DJM-909
SYS : X.XXX
FPGA : X.XXX
DSP : X.XXX
LCD : X.XXX
Release
Release
Release
20
Calibration Mode : CANCEL
POWER OFF
Efect Mode : CANCEL
POWER OFF