Installing Water Resistance Cap - Huawei IPC6332-MIR Quick Start Manual

Hide thumbs Also See for IPC6332-MIR:

Table of Contents

IPC6332-MIR

Quick Start Guide

Figure 3-14 Install the Front Cover

Step 5 Tear off the protection film softly to complete the installation.

----End

3.5 Installing Water Resistance Cap

Purpose

When using the camera outdoor, using a waterproof cap is recommended to prevent the wire

from short circuit.

Procedure

Step 1 Cut the crystal head of a network cable.

Step 2 Route the cable to the secure hook, rubber ring, and the cap.

Step 3 Tuck the rubber ring into the cap.

Step 4 Connect a crystal head for the cable.

Step 5 Put the thin ring on the network cable of the camera side.

Step 6 Connect the network cable and put the water resistance cap on the network interface of the

camera side. Fasten the secure hook.

Issue 02 (2014-12-25)

NOTE

l Do not tear off the protection film until the installation is completed.

l Do not touch the inside face of the bubble with your hands.

Huawei Proprietary and Confidential

3 Installation

Table of Contents