Advertisement
NB. The padded aperture cover is not designed to be load bearing.
SELF PROPELLED WHEELS
On the self propelled model, the 580 mm diameter rear wheels are packed separately.
The wheels are attached to the frame by the large square silver brackets on the rear
vertical legs of the frame.
1.
Remove the wheels from their packaging.
2.
Hold the wheel in position against the silver bracket so that the centre of the
wheel is against the locating hole in the bracket.
3.
Press the black button in the centre of the wheel to pass the locking bar axle
through the bracket into the frame. Do not apply excessive force – when
positioned correctly it should slide gently into the locating hole.
4.
Continue to apply pressure until the button clicks into place and will move no
further.
Check that the wheel is correctly installed by pulling it away from the frame – if
5.
correctly installed the wheel will remain attached: If the wheel comes away
from the frame follow steps 2 – 4 again until it is correctly installed.
COMMODE BUCKET
To remove the commode bucket, simply slide the bucket out from the chrome runners
at the rear of the commode. Cover the top of the bucket to avoid splashing, carefully
dispose of the contents into a proper sluice or WC. Never use an open drain, sink or
basin. This could cause a serious health risk. To avoid the possibility of trapping, do
not slide the commode pan on or off the rails while somebody is sitting on the chair.
Clean out the residue with a suitable disinfectant and refit to the commode after use
NB. Always remove the commode bucket prior to removing the grey horseshoe
seat.
CLEANING
Our equipment can be cleaned and or disinfected as per MHRA guidance on
decontamination MHRA DB 2003(06).
Do not use abrasive cleaners as this could damage the surface of the equipment. For
cleaning, wipe with a clean cloth soaked in detergent solution and wring out.
Depending on the detergent manufacturer's instructions the solution may be heated.
Wipe all surfaces of the equipment and the cloth should be re-immersed periodically
and the detergent changed frequently. The detergent should be rinsed or wiped off
using a clean cloth immersed in clean water and wrung out.
To disinfect make sure the equipment has been cleaned and dried and then wipe over
with a clean cloth and a compatible liquid disinfectant. After disinfecting clean with
clean water and dry.
When using detergent or disinfectants then please refer to manufacturers' instructions
and if unsure then consult your local Infection Control Specialist for advice.
When using moist heat the equipment can be held at 81°c for at least one minute to
achieve disinfection.
APERTURE COVER
Assembly and Operating Instructions
4
Ver. 5 08/2014 (2011)
Advertisement
