Advertisement
Installation
Distance for the effective operation of the device: select a
suitable site for the installation of the sensor, it is necessary
to reset the factory settings using a special needle. After this
multi-function gateway will make a corresponding sound,
which signals that you chose the optimal distance between
the sensor and a multi-function gateway.
Motion Sensor
Method 1: You do not have to stick with the back of the
sensor to the wall or other surface, you can simply install it
in the right place.
Method 2: Remove the protective cover (in kit of your device
you get adhesive membrane) and you can stick the sensor
Sensor for windows / doors
1 Remove the protective membrane
During installation, try
Attach the device to the desired
surface (recommended to
as much as possible to
install the primary sensor on the
balance the location of
immovable surface, and a magnet
the primary sensor and
on the surface, which is expected
the magnet at a special
mark (see Figure 2)
to be opened. The allowable
distance between the main
sensor and magnet 22mm.
to the back of any surface or wall.
* Optimal height at which the sensor should be, 1.2-2.1m.
At a height of less than 1.2 m, the detection range becomes
smaller, but it does not affect its use. When you place the
sensor more than 2.1m, in the room will appear blind spots,
so there can be problems with finding people, animals.
* During installation, pay special attention to induction lens.
It should be directed to the side of space that you want to
monitor. Install or stick the sensor maximum close to the
edge of a table or cabinet.
The main hub
1 Remove the protective membrane
2 Attach the unit to the desired
surface
* Glue unit on a dry surface
* Place the hub on the main non-metallic surface, since it
affects its work
Remove the protective
membrane
1 Stick to any desired surface
Optimal detection range /
Optimal detection radius
New devices
To add a new device or restore the factory settings, you
can use one of the two following methods:
Method 1: Open the smart home and on the main page
of the multifunction gateway click on «add device» by
following the instructions set out below, do a factory reset.
Method 2: Continuously press three times on button of a
multifuntion gateway, follow the instructions set out below,
do a factory reset.
* When you connect smart devices without a hole for reset,
read the instructions for use of such a device
* When connecting the device to another gateway, you
need to reset the device, and then add a new device by
following the above described scheme.
Advertisement
