Table of Contents
Advertisement
Operating and Installation Instructions
6.
LED status indicators
There are three LED status indicators on the front panel of the ETHSW50K. In addition, each
RJ-45 port has 2 LED status indicators.
LED
Indicator/Colour
On / green
P1
Off
On / green
P2
Off
On / red
Alarm
Off
On / green
RJ-45 Ports
Port 1 to 5
Flashing green
Link/Activity
Off
RJ-45 Ports
On / yellow
Port 1 to 5
Off
Speed
7.
Configuration and settings
The ETHSW50K is an unmanaged and plug-and-play switch. The switchable Flooding Storm Control
function protects against unwanted allocation of the available transmission rate by Broad or Multicast
data frames. In addition, the ETHSW50K has a redundant voltage input and a fault relay for signalling
the fault of a power supply unit or a power supply.
7.1
Setting the DIP switches
Display
PIN 1
On
off
PIN 2
On
off
Description
Primary power supply is active
Primary power supply not available
Secondary power supply is active
Secondary power supply is not available
Power supply failure
(if power alarm is activated)
No power supply failure
(if power alarm is activated)
Ethernet link established (link up) / no data transmission
Ethernet link established (link up) / data transmission
Ethernet link not established (link down)
Ethernet link with 100 Mbit/s established
Ethernet link with 10 Mbit/s established or Ethernet link
not established (link down)
Fault alarm contact Power Activate alarm
Fault alarm contact Power Deactivate alarm
Activate Flooding Storm Control
Deactivate Flooding Storm Control
- 9 -
Stand: 24.05.2019
Advertisement
Table of Contents
