Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Atmos Chair E 2
Summary of Contents for Atmos Chair E 2
- Page 1 MedizinTechnik English ATMOS Chair E 2 ® GA1 GB .130204.0 2017-10 Index: 05...
-
Page 2: Table Of Contents
Troubleshooting ..........13 Accessories and spare parts ......14 Accessories ............14 Spare parts ............14 Further information, accessories, consumables and spare parts are available from: Technical data ...........15 ATMOS 10.0 Disposal .............16 11.0 Notes on EMC ............17 MedizinTechnik GmbH & Co. KG Ludwig-Kegel-Straße 16... -
Page 3: Introduction
Chair E 2 and are therefore a must besides regular cleaning. ® Repair work and period tests may be carried out only by expert personnel authorised by ATMOS. By applying only original spare parts you will have the guarantee that operational safety, readiness for work and the value of your ATMOS Chair E 2 will be preserved. -
Page 4: Explanation Of Pictures And Symbols
Graphic symbols contained in these operating instructions Warning, special diligent notice Important information Symbols of ATMOS Chair E 2 ® Degree of protection type B Order number This product complies with the relevant requirements of EU Directives... -
Page 5: Scope Of Supply
1.5 Scope of supply Prior to dispatch, the ATMOS Chair E 2 was subjected to an extensive functional test and was carefully packed. ® Nevertheless, please compare the contents of the shipment on completeness immediately upon receipt (see delivery note). -
Page 6: For Your Safety
For your safety • The Chair E 2 has been designed in accordance with IEC • The Chair E 2 is not designed for the use in medical areas 601/ EN 60601. The equipment conforms to VDE Safety with an explosion hazard. Explosion-hazardous areas... -
Page 7: Setting Up And Starting Up
Foot switch for adjusting the seat height 3.3 Electrical connection The ATMOS Chair E 2 is supplied with a power cable and ® IEC connection. The power cable is plugged into the IEC connection on the rear side of the base and is connected to a properly installed earthed socket. -
Page 8: Operation
(fi g.2): = Up = Down Furthermore, the ATMOS patient chair features an “Auto – Down (homing)” function, driving the seat down to its lowest level after a short tap on the foot switch. Pressing the right foot switch for less than 0.5 seconds will move the chair... -
Page 9: Rotating The Upper Part Of The Chair
4.0 Operation 4.3 Rotating the upper part of the chair The upper part of the chair with the patient can be completely rotated after having loosened the brake with the locking lever , fi g. 3). The upper part with the patient can then be rotated in the desired direction. -
Page 10: Adjusting The Manual Backrest
Lever element Arm rests, base part and back rest are coupled for synchronous movements. The ATMOS Chair E 2 can optionally be equipped with an ® electric backrest. The adjustment is possible both by means of a foot switch ( , fi g. -
Page 11: Adjusting The Head Rest
4.0 Operation 4.8 Adjusting the head rest The head rest (fi g. 8) can be brought into a lower position by simply pulling the retaining strap into a lower position or by pushing it into a higher position. To remove the headrest, the retaining strap must be pulled out completely from the backrest. -
Page 12: Cleaning And Care
• The surface of the ATMOS Chair E 2 is resistant against all the recommended surface disinfectants stated in chapter 5.3 and 5.4. Nevertheless after a longer period of use discolouration could occur. Polar solvents (e.g. acetone or chlorinated hydrocarbons (CC)) may not be used for cleaning and disinfection. -
Page 13: Maintenance And Service
• Check connection at wall socket • No mains voltage • Check main fuse • Check power plug on perfect fi t at the device • Defective fuse • Exchange of fuse Should a malfunction still occur, please inform the authorized ATMOS customer service immediately. -
Page 14: Accessories And Spare Parts
8.0 Accessories and spare parts 8.1 Accessories Child seat On request 8.2 Spare parts... -
Page 15: Technical Data
9.0 Technical data Voltage 230 V~ ± 10 %; 50 Hz Special voltage:120 V~ ± 10 %; 60 Hz Current consumption 2.5 A (approx. 3.1 A with the additional electrical back-rest adjustment) Power consumption 520 VA (approx. 700 VA with the additional electrical backrest adjustment) Fuse 3.15 A T (230 V~) Operating time... -
Page 16: Disposal
10.0 Disposal • The ATMOS Chair E 2 does not contain any hazardous materials. ® • The housing is recyclable. • Device and accessories must be decontaminated prior to disposal. • Pay attention to a careful separation of the different materials. -
Page 17: Notes On Emc
11.1 Guidelines and Manufacturer's Declaration - Emissions The ATMOS Chair E 2 is intended for use in the electromagnetic environment specifi ed below. The customer or user of the ® ATMOS Chair E 2 should ensure that it is used in such an environment. - Page 18 11.3 Guidelines and Manufacturer's Declaration - Immunity The ATMOS Chair E 2 is intended for use in the electromagnetic environment specified below. The customer or user of the ® ATMOS Chair E 2 should ensure that it is used in such an environment.
- Page 19 Chair E 2 is used exceeds the above compliance level, the ® ATMOS Chair E 2 is to be observed to verify the intended use. If abnormal performance characteristics are noted, additional ® measures might be necessary, e. g. a changed arrangement or another location for the ATMOS Chair E 2 ®...
-
Page 20: Ludwig-Kegel-Straße
ATMOS MedizinTechnik GmbH & Co. KG Ludwig-Kegel-Straße 16 79853 Lenzkirch / Germany Phone: +49 7653 689-0 atmos@atmosmed.de www.atmosmed.com...
Need help?
Do you have a question about the Chair E 2 and is the answer not in the manual?
Questions and answers