Function Test - Carrier 42XQ Series Installation And Start-Up Instructions Manual

Selecting the DEFLECTOR mode (louver)
To enter the deflector model selection:
• Check that the CRC is ON and keep the button
Then the selected setting of the deflector is displayed.
• Pressing the buttons
deflector between oscillating and auto. The two settings are displayed as follows:
"S" with the Oscillating Deflector icon - represents the Oscillating Deflector
"A" with the Auto Deflector icon - represents the Automatic Deflector
The fan icon is also displayed in Deflector mode.
Press the key
automatically after no button has been pressed for 10 seconds.
If the deflector setting has been modified, the last value displayed is the new
deflector setting for the system. The only way to abort a deflector change is to change
the value back to its original value.
ATTENTION !!!
If the units are grouped together in CRC,
all of the units will end up with the same
deflector value.
8.6

Function Test

• Perform the function test after the units have been installed in the location and
after performed a test to detect any gas leaks.
• Check all of the electrical connections (instructions and diagram of the electrical
connections).
• Insert the batteries into the remote control and leave it disconnected.
• Connect the system to the electrical current.
• Press the
5 seconds. The clock digits show the first configuration item (Src = service test).
• After completing the test, press the button
28
and
to exit the Deflector mode selection. This mode is exited
button and the remote control and keep them pressed down for at least
pressed down for 5 seconds.
permits the user to modify the setting of the
NOTE
Selecting DEFLECTOR mode is not available
in OFF mode.
to exit the configuration menu.