Advertisement
USER GUIDE:
Shower Chair
COMFORT VALUE
4.4.3 Replacing the Arm Pad
The chair is fitted with two rubber moulded arm pads. These are secured by two pozi pan self-
tapping screws.
To remove the arm pad: unscrew the screws
To refit: sling the fitting holes in the arm pad with the holes on the tubular arm and secure
with a self-tapping screw.
NOTE: Ensure the screws are tight to avoid the arm pad twisting
4.5 Footrest
Do not stand on the footrests as this may result in the chair tipping. The footrests have been
designed to be removed or folded away to ease access to and from the chair.
4.5.1 Lock & Removal
The footrest is designed to swing away. It is detachable by a simple single-handed
operation.
To lock: the footrest is locked in place by a V-groove and a plastic clip.
To remove the footrest: lift upwards.
4.5.2
Adjustment
The footrests are adjustable in height:
i. Remove the footrest from the frame by pulling upwards
ii. Remove the black pin on the side footrest socket
iii. Refit pin in required hole
iv. Refit footrest
4.6 Seat, Removal, Re-fitting
The chair is fitted with a gap front/horseshoe seat as standard, secured with grey snap on clips.
To remove the seat: pull seat upwards sharply
To refit the seat: align the snap on clips and push / press down firmly
4.7 Backrest - Removal and Refitting
The backrest is not fixed to the main frame of the chair.
Clean with soap and water and mild anti-bacterial cleaner, do not use bleach
To remove / fit the backrest: slide over the backrest upright tubes
4.8 Accessories
4.8.1 Commode pan
The commode pan is mounted on a bracket under the seat. The commode pan rack is bolted
to the support plate.
Fitting the rack:
i. Align the holes in the rack with the slots in the support plate
ii. Fit bolt through the support plate and the commode rack
iii. Fit the washer and finger tight the nut
iv. Adjust the width of the rack to support the pan and tighten the nuts to secure the rack
It can be removed from the front or the rear of the chair. Undo the four fixing nut &
bolt using 10mm spanner and 4mm allen key (not supplied).
NOTE: Clean by hand only using warm water and a suitable detergent and antibacterial agent or bleach, this
pan is not suitable for pan washers
(CVSC/ATT + CVSC/SP)
UG/CVSC-01
Advertisement
