FujiFilm instax mini 70 User Manual page 42

Problems
The film pack won't load
into your camera, or won't
load into your camera
smoothly.
The film cover cannot be
ejected.
EN
The LCD looks black.
The battery becomes
exhausted quickly.
Printed pictures
Problems
Part or whole finished
print is white.
The finished print looks
over exposed. (White in
color)
42
Possible Causes
1 The film pack is not for your
camera.
2 You are not loading the film
pack correctly.
● The battery power is low.
● The camera is too hot for
operation.
● The batteries are not the same
type.
Possible Causes
● The back cover was opened
before you have used up the
film.
1 The ambient temperature is
low (below +5°C/+41°F).
2 The AE light sensor window
or flash sensor window was
covered.
Solutions
1 Use FUJIFILM INSTAX mini film only. (No other films can
be used.)
2 Match the yellow line on the film pack with the yellow positioning
mark in your camera. Follow the INSTAX mini film pack instructions.
● Replace both batteries with new batteries and load the
film pack again.
● Put the camera in a cool place. The LCD should return to
normal once it cools down.
● Replace both batteries with new CR2 lithium batteries of
the same brand/type.
Solutions
● Do not open the back cover until you have used up the
film; otherwise, the rest of the film may be exposed and
ruined for use.
1 Before taking pictures, place your camera in a warm
place to bring it to room temperature.
2 Be careful not to block the AE light sensor or flash sensor
window, or so that nothing blocks it.