Table of Contents
Advertisement
• HDD test...
Tests whether the HDD returns a response when communication is established with the hard disk drive. The HDD can be
tested without damaging the HDD data (without formatting the HDD) in this test since the HDD data is tentatively stored
in memory during the test.
If the main power is turned off by mistake while the test is under way, the HDD data can be damaged. Tests the following
test automatically.
1. HDD interface test (Tests whether or not the HDD is recognized)
2. HDD seek test
3. HDD read test
4. HDD write test
5. HDD random read test and random write test (It takes about 2 hours for the 18 GB HDD. This time is a guideline and
changes depending on the model.)
6. Returns to the main menu.
• Keyboard test...
Tests the keyboard. When the "Auto select" menu is selected, the keyboard type in use is recognized from the model
information that is written in ROM when shipped from the factory and the test is executed accordingly. When a specific
keyboard type is selected such as US, UK, or JP, then the keyboard of the selected type is tested. If the model of your
computer is JP and the keyboard type is replaced by either the US type or UK type keyboard, select the keyboard type after
it is replaced.
NOTE: The "Fn" key can be checked by pressing the "Fn" and "Insert" keys at the same time. Other keys can be
checked by pressing the respective keys.
• LED test...
Tests the LED. This test turns on one LED after another. The person conducting the test must visually check whether each
LED is normal or not.
• Main Memory test...
Tests the main memory. The Main Memory test contains the following three test menus. Select the desired menu that suits
your need. The test is exited automatically when the respective test items end normally.
⋅ Fast: Tests once. (Taking one and half minutes to two minutes)
⋅ Medium: Test ten times.
⋅ Heavy: Test twenty times.
Press the "Esc" key to abort the test.
• Main System test...
Tests the fundamental functions of the CPU, etc. The test is exited automatically when all test items end normally.
• FAN test...
Tests the fan. Tests whether the fan rotates and stops. Listen to the rotating sound or feel the wind of the fan to judge
whether the fan rotates and stops. The test procedure appears on display. Perform the FAN test following the messages on
display. Press "Y" to resume rotation when the fan comes to stop. Press "Y" when the fan starts rotating indicating that the
test ends in success.
2-5
Confidential
PCG-F650/F680/F690 (UC)
Advertisement
Table of Contents
