Camera Run/Stop; Lens Mapping Feature - Teradek CTRL.1 Quick Start Manual

CAMERA RUN/STOP

Connect a camera cable from the CAM/Control port on the Latitude to the camera, then
1
navigate to MENU>CAMERA on the CTRL.1 to indicate which camera you have connected.
Press the REC button on the controller
2
NOTE: If using a RED camera, the camera serial communication setting must be set to RCP
(Redlink Command Protocol) for the unit to operate.
LENS MAPPING
The Lens Mapping Package can be purchased with the CTRL.1, or as a seperate upgrade. After
purchasing the Lens Mapping Package, use the following steps to activate it.
Press the MENU button, then use the ▼ button to navigate to the ADV (Advanced) menu. Press
1
the SET button to access the menu.
Navigate to the LICENSES menu. Press SET to display the UID number.
2
To generate a license key, enter the controller's UID, the upgrade code, and your email address
3
on activate.teradek.com.
On the same screen displaying the UID number, select YES to enter the license key.
4
(C)
to start/stop recording on the camera.
4