Using The Control Box; Mode - Waeco MW-SSC-01 Operating Manual

_MW-SSC-01.book Seite 18 Donnerstag, 27. September 2007 4:31 16

Using the control box

➤
Conenct the green cable to the positive wire of the brake light or the hand brake in-
dicator light (optional).
Note
Cables that are not connected must be insulated to prevent malfunctions and
damage to the device.
➤
Connect the yellow cable to the positive cable of the reversing light (optional).
➤
Set the dip switch 4 to the appropriate brake.
7 Using the control box
The control box switches on automatically when the speed falls below the limit set. It
then switches the connected MagicWatch system on.
The control box has different modes of operation. You must set the speed at which the
control box is activated.
When the control box is activated, the red LED (5 2, page 4) on the housing glows.
7.1 Setting the operating mode
If the speed drops below the set value, the control box switches on. It acts depending on
which of the following operating modes you have selected:
Operating
Meaning

mode

Mode 1 When the vehicle comes to a standstill, the control box switches off
immediately.
Mode 2 When the vehicle comes to a standstill, the control box remains
switched on.
Mode 3 When the vehicle comes to a standstill, the control box switches off
after 10 seconds.
Mode 4 When the vehicle comes to a standstill, and the brake light con-
nected to the control box is activated, the control box switches off
immediately. If the brake light connected to the control box is not
activated, the control box remains switched on.
Mode 5 When the vehicle comes to a standstill, and the brake light con-
nected to the control box is activated, the control box switches off
after 10 seconds. If the brake light connected to the control box is
not activated, the control box remains switched on.
➤
Set the dip switches to the desired operating mode (6, page 5).
18
MagicWatch