Getting Started - Remington Ultimate Series Manual

PARTS
1. On/off switch
2. Head and cutter assembly
3. Hair pocket
4. LED display
5. Pop-up trimmer
6. Trimmer release button
7. Charging pins
8. Charging stand

GETTING STARTED

CHARGE THE SHAVER:
Note: This shaver is for cordless use only.
1. Ensure the appliance is turned off.
2. Connect the charging stand to the adaptor and then to the mains.
3. Place the shaver in the charging stand.
4. Charge for at least 24 hours when using for the first time.
• To preserve the life of your batteries, let them run out every 6 months then recharge
for 24 hours.
• The appliance adapts automatically to a mains voltage between 100V and 240V.
R7
• When the charge is low, the upper LED will illuminate red.
• When charging the lower LED will illuminate green. When fully charged both LEDs will
be off.
• Allow 4 hours for a complete charge.
R8
• The fuel gauge will display the amount of charge left when the shaver is on. When
charging, the LEDs cycle in a rotating pattern. When fully charged all LEDs will come on
then turn off.
• Allow 90 minutes for a full charge.
INSTRUCTIONS FOR USE
It is recommended that you use your new shaver daily for up to four weeks to allow time for
your beard and skin to become accustomed to the new shaving system.
SHAVING
1. Switch the shaver on.
2. Stretch the skin with your free hand so the hairs stand upright.
9. Beard trimming attachment
10. Comb
11. Comb adjustment dial
12. Adaptor (not shown)
13. Headguard (not shown)
14. Cleaning brush (not shown)
15. Storage case (not shown)
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
UA
BG
AE
5