Advertisement
Î Motoric turnout drives
Motoric turnout drives can not be controlled by a decoder of the Z1 or ZH1
series. Apply a Z2 series decoder instead.
Î Additional key buttons for switching turnouts etc.
Turnouts or semaphore signals can be switched
manually or automatically (train controlled)
by key buttons, reed relays or light barriers
attached in parallel to any function output
terminal. Applying the same principle lamps
or LEDs can be switched on by key buttons
attached in parallel to the function output.
Attach extra key buttons RQO\ to the brown ground terminals (Z1) or the
blue terminal (ZH1). Do not attach extra key buttons to the track signal
or other power supplys. You risk the destruction of the decoder.
When using additional key buttons we recommend to use turnouts with
limit stop to prevent excessive loads due to long switching pulses.
Î Evaluation of key buttons etc
Decoder of the all-in-one class are able
to evaluate key button levels or reed
relays for the signal aspect generator.
The devices have to be attached using
DGGLWLRQDO UHVLVLWRUV RI Ÿ
2SHUDWLQJ PRGHV XVLQJ WKH SURJUDPPLQJ EXWWRQ
Use the Prog button to select one of the following modes for Z1/ZH1:
Command Accessory device
1
1
2
2
3
3
4
4
Turnouts
(no fading)
Light signals
Lightdecoder
Key button
for drive
220 :
A0
A1
Operating mode
¼ s pulse length
½ s pulse length
1 s pulse length
2 s pulse length
continous operation
two aspects (red/green)
three aspects (red/green/green-yellow)
Ausgänge jeweils einzeln geschaltet
A3
A4
A5
A6
A7
A2
A3
A4
A5
A6
Turnout
Z1
ZH1
Z1
A7
Advertisement
