Actions On Dock; History; Calibration; Bump Test - ION CUB Instrument User Manual

Actions on Dock

When you place a Cub in a Cub Doc Docking Station, logged data is automatically copied to the
connected PC. Other actions may also take place, as specified by ticking the checkboxes in this
section, in the order they are listed on the page.
Note that this function is in addition to the automatic copying of logged data mentioned above. Such
data is viewed using CubPC, but is encoded and cannot be edited. Data transferred manually to CSV
files may be freely edited and also loaded by other software.
Minimum and Maximum SPAN parameters can be set which, if exceeded, will automatically
recalibrate the Cub instrument. Check the
The last two actions are only available on Calibration Docking Stations.

History

If logged data more than a certain number of days old is to be deleted from the PC, tick the checkbox
in the History section of the page and enter the number of days in the field next to it.

Calibration

Please refer to the Calibration section

Bump Test

Use this setting to specify whether during bump tests the bump gas used is the calibration gas or the
PID gas selected for the Cub.
Unrivalled Gas Detection.
Cub data is downloaded to PC in CSV format. The location for the file is
selected using the Browse button.
Data is deleted from the Cub once it has been downloaded to the PC.
The Cub's internal clock is synchronised to that of the PC.
The Cub's firmware is automatically updated if an update is
available. Data stored on the Cub will be deleted.
The Cub will be recalibrated. This function works independent of
the previous bump test function. Data stored on the Cub will be
deleted.
for details of these settings.
See the Bump Tests topic
Page 25 of 46
Cub Instrument User Manual V2.4
The Cub is automatically bump
tested. Data stored on the Cub
will be deleted.
checkbox.
for further details.
ionscience.com