5. Using the CubPC Software and Downloading Data
Overview
The CubPC software is used to carry out the following procedures on a PC:
•
View Cub details and downloaded statistics.
•
Set preferences for Cubs.
•
Calibrate Cubs.
•
View details of and set preferences for Cub Docs.
PC Requirements
CubPC software is run on a PC using Windows Vista, Windows 7 or Windows 10. The PC must have
.NET Framework 3.5 Service pack 1 or above installed. This can be downloaded from:
http://www.microsoft.com/en-us/download/details.aspx?id=25150
Downloading and Installing
Download the CubPC software from our website at:
https://www.ionscience.com/wp-content/uploads/2018/06/0.0.0.51.zip
Install the CubPC by following these instructions:
https://www.ionscience.com/wp-content/uploads/2016/10/Cub-Installation-instructions.pdf
Connecting Docking Stations and Cubs to a PC
Connect your PC to either a Cub Doc Data Dock or Calibration Dock using the provided USB cable as
shown below:
The Cub Doc must be powered on (the Charge LED should be green) for a USB connection to be
made.
Mains cables for the US, EU and Australia are also available
Unrivalled Gas
Detection.
Cub Instrument User Manual V2.4
Page 17 of 46
ionscience.com