Required Material And Tools - Viega 8350.33 Instructions For Use Manual

External sensors (optional)
3.1.2

Required material and tools

Material
Tool
WC flush actuation
Fig. 11: Protected zones
According to the applicable regulations, installation of the power pack in
the protected zones 0 and 1 of shower rooms and bathrooms is not per-
mitted, see Ä „Regulations from section: Fields of application /
Mounting conditions" on page 6 .
Viega recommends installing the power pack outside of the protected
zones 0–2.
If external sensors are to be connected to the control, their connection
cables or empty pipes must be laid in the cistern before tiling is begun.
The following material is required for mounting:
Ä „Suitable manual flush plates" on page 8
a suitable flush plate
n
Ä „Optional accessories" on page 16
Programming set
n
if necessary, empty pipe from power pack into the cistern
n
if necessary, accessories for the extension of the system
n
2.4.4 „System expansions" on page 11
The following tools are required for mounting:
flat screwdriver
n
spanner (SW 19)
n
n knife (cutter)
Handling
Ä Chapter
19 from 42