Table of contents Table of contents About these instructions for use 1.1 Target groups 1.2 Labelling of notes 1.3 About this translated version Product information 2.1 Intended use 2.1.1 Areas of use 2.2 Product description 2.2.1 Overview 2.2.2 Technical data Handling 3.1 Assembly information 3.1.1...
This restriction does not extend to possible operating instructions. The installation of Viega products must take place in accordance with the general rules of engineering and the Viega instructions for use.
About these instructions for use About this translated version This instruction for use contains important information about the choice of product or system, assembly and commissioning as well as intended use and, if required, maintenance measures. The information about the products, their properties and application technology are based on the current standards in Europe (e.g.
Product information Product information Intended use 2.1.1 Areas of use The Prevista Pure bidet block is suitable for mounting wall-mounted bidets and for walling in or around. This model 8367 has height-adjust‐ able and width-adjustable wall plates. Product description 2.2.1 Overview Fig.
Product information 2.2.2 Technical data The product has the following technical data: frame Galvanised steel Wall plates Gunmetal ½ inch Drain elbow DN 40 Prevista Pure bidet block...
Handling Assembly 3.2.1 Mounting a pre-wall block Mounting on a solid wall ▶ Bend open the four fixing lugs on the side by 90°. ▶ Determine the fixing height. ▶ Align the block horizontally. ▶ Drill the holes and attach the dowels. Prevista Pure bidet block...
Page 9
Handling ▶ Attach the block to the wall with the screws supplied. ▶ Open the pipe clamp. ▶ Insert the drain elbow. ▶ Close the pipe clamp. ▶ Set the height of the drain elbow. Prevista Pure bidet block...
Page 10
Handling ▶ Set the height and width of the wall plates. ▶ Turn in the threaded rods by hand. ▶ Brick the block in and up completely. ▶ Tile the pre-wall. Prevista Pure bidet block...
Handling Mounting in a solid wall ▶ Align the block horizontally and fix in the wall using mortar. ▶ Brick the block in and up completely. ▶ Plaster the block completely. Disposal Separate the product and packaging materials (e. g. paper, metal, plastic or non-ferrous metals) and dispose of in accordance with valid national legal requirements.
Page 12
Viega Technology GmbH & Co. KG service-technik@viega.de viega.com INT • 2020-02 • VPN190598...