How To Install The Seat; How To Assemble The Steering Wheel - Murray 387002x92NA Instruction Book

HOW TO INSTALL THE SEAT

Use the fasteners shown below to install the seat. The fasteners are
shown at full size.
(A)
1001054
1. Carefully remove the plastic bag from the seat.
2. Align the holes in the seat hinge to the holes in the seat
(Figure 4). Fasten the seat to the seat hinge with the fasteners
as shown.

HOW TO ASSEMBLE THE STEERING WHEEL

Fasteners are not required to assemble the steering wheel. Attach
the steering wheel as follows:
1. Make sure the front wheels point forward.
2. Place the bellows in position on the console. (Figure 5)
3. Slide the steering wheel and steering post thru the bellows
and console. Make sure the end of the steering post aligns with
the pinion gear. Push on the steering wheel. The steering
post will lock onto the pinion gear.
Pull on the steering wheel. Make sure that the steering post
is locked in place.
Bellows
F–040700C
ASSEMBLY
(B)
17x47
Console
Figure 5
3. Check the operating position of the seat. If the seat needs to
be adjusted, loosen the two wing bolts. Slide the seat forward
or backward along the seat adjusting holes as shown. Tighten
the wing bolts (A).
Steering Wheel
Steering Post
Steering Post
Pinion Gear
12
Seat
Seat Hinge
Seat
Adjusting Hole
B
A
Figure 4
Hub
Cover
Figure 6