Occupational Safety - ABB TPR56FV Series Assembly Instructions Manual

Assembly Instructions / TPR56FV.. - TPR61FV..
2 Safety / 2.3 Occupational safety
2.3

Occupational safety

General
WARNING
Injuries to persons
Severe injuries to personnel or fatal accidents can be caused by mechanical
influences as a consequence of hazardous and inadequate operational pro-
cedures or non-compliance with safety and health standards.
When working on the turbocharger always wear safety footwear and pro-
u
tective clothing to protect against mechanical hazards.
Keep personal protective equipment in perfect condition.
u
Obey mandatory signs.
u
Observe the general rules for occupational safety and prevention of accidents.
u
Only perform operations that are described in this chapter.
u
Only perform operations for which you have received instruction or training.
u
Wear safety footwear to protect against mechanical hazard and risk of falling.
Wear protective clothing.
WARNING
Risk of falling
When working on the turbocharger, there is a risk of falling.
Do not climb onto the turbocharger or onto attached parts and do not
u
use them as climbing aids.
Use suitable climbing aids and working platforms for work above body
u
height.
Only perform work on the turbocharger when you are in a physically and psychologically
u
stable condition.
Only work with suitable tools, equipment and appliances that function properly.
u
Keep the workplace clean; clear away any loose objects and obstacles on the floor.
u
Keep the floor, equipment, and turbocharger clean.
u
Have oil binding agents ready and provide or keep oil pans at hand.
u
Welding work close to the turbocharger
If welding work is being carried out in the vicinity of the turbocharger, cover the filter si-
u
lencer so that the filter mat is not damaged.
Remove combustible objects and substances out of the range of flying sparks.
u
Cover all connections on the turbocharger so that no foreign objects can get into the tur-
u
bocharger.
© Copyright 2018 ABB. All rights reserved. HZTL455311P0033_EN Revision B May 2018