Table of Contents
Advertisement
OPERATIONAL INSTRUCTIONS
HEADPAD ADJUSTMENT AND USE
The HEADPAD(63) is designed to support the natural curve
of your neck. It can be used to provide comfort, support and
postural alignment for reformer exercises that are performed
while lying on your back. Do not use the HEADPAD(63) for
exercises that require you to lift your hips higher than your
head.
With the HEADREST(14) in the flat position, place the
HEADPAD(63) on top of the HEADREST(14) with the thickest
part of the HEADPAD(63) under your neck. Make sure that
the elastic strap on the HEADPAD(63) is around the
HEADREST(14).
STORAGE
1.
Store the AeroPilates
2.
It is recommended that two people be available to move the AeroPilates
3.
To move the AeroPilates
the FRONT FRAME(1) to prevent the CARRIAGE(7) from moving. Second, lift up the AeroPilates
Premier 690 from the REAR FRAME(2) to move the AeroPilates
wheels on the FRONT FRAME(1).
MAINTENANCE
The safety and integrity designed into the AeroPilates
AeroPilates
Premier 690 is regularly examined for damage and wear. Special attention should be given
to the following:
1.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
2.
Worn or damaged components should be replaced immediately or the AeroPilates
removed from service until repair is made.
3.
Verify that the WARNING LABEL(53) is present and legible. Replace the WARNING LABEL(53) if it is
missing or damaged.
4.
Verify that the ROPES(18) are properly installed on the PULLEY SETS(22).
5.
Check the condition of the ROPES(18) and replace if they are frayed or worn.
6.
Check the PLASTIC SNAP HOOKS(19) on the ends of the ROPES(18). Replace the ROPES(18) if
PLASTIC SNAP HOOKS(19) are damaged or deformed.
7.
Check the TENSION CORDS(10). If a TENSION CORD(10) is stretched and loose, re-tie the knot on
the end of the cord. Replace TENSION CORDS(10) that are frayed or worn.
8.
Check the BUNGEE CORD(52) on the CARDIO REBOUNDER(50) for wear. Replace the CARDIO
REBOUNDER(50) if the BUNGEE CORD(52) is frayed or worn.
9.
Check the PULLEY SETS(22) for excessive wear. Replace worn PULLEY SETS(22).
10.
Check the HAND STRAPS(20) for damage. Replace damaged parts.
11.
Check the FOAM SLEEVE(6) and FOAM PADS(16) and replace if damaged or worn.
12.
Check the STOP PLATES(30, 31) for looseness or damage and replace any damaged parts.
13.
Check the CUSHION(13) and replace if it is damaged or worn.
14.
Check and clean the ROLLERS(8) and the rolling surfaces on the rails. Clean by wiping with a dry cloth.
15.
Only Stamina Products supplied components shall be used to maintain/repair the AeroPilates Premier
690.
16.
Keep your AeroPilates
Premier 690 in a clean, dry place.
Premier 690: First, attach one of the TENSION CORDS(10) in the slot on
Premier 690 clean by wiping with an absorbent cloth after use.
Make sure that both FOAM PADS(16) are in
the carriage when using the HEADPAD(63)
attached to the HEADREST(14).
Premier 690 can only be maintained when the
11
Premier 690.
Premier 690 with the transport
Premier 690
Advertisement
Table of Contents
