Hardware Identification Chart; Carriage Bolt (M8 X 1.25 X 60Mm); Carriage Bolt (M8 X 1.25 X 85Mm); Screw, Round Head (M3 X 10Mm) - Stamina INTONE 15-0200 Owner's Manual

HARDWARE IDENTIFICATION CHART

This chart is provided to help identify the hardware used in the assembly process. Place the washers, the
end of the bolts, or screws on the circles to check for the correct diameter. Use the small scale to check the
length of the bolts and screws.
3/16" 1/4"
0 1/2 1
0 10 20
6
NOTICE: The length of all bolts and screws except those with flat heads is
measured from below the head to the end of the bolt or screw.
Flat head bolts and screws are measured from the top of the
head to the end of the bolt or screw.
All hardware are already attached to the parts. After unpacking the unit, make sure that you have all the
following items on the parts.
5/16" 3/8"
1/2 2 1/2
30 40 50 60
8 10
Part No. and Description
56
57
60
64
65
69
74
75
1/2"
3 1/2 4
70 80 90 100 110 120 130 140 150
MILLIMETERS
12

Carriage Bolt (M8 x 1.25 x 60mm)

Carriage Bolt (M8 x 1.25 x 85mm)

Screw, Round Head (M5 x 0.8 x 10mm)

Bolt, Hex Head (M8 x 1.25 x 20mm)

Bolt, Hex Head (M8 x 1.25 x 40mm)

Acorn Nut (M8 x 1.25)

Arc Washer (M8)

Washer (M8)

5
INCHES
1/2 5 1/2
length
length
6
in.
mm.
Qty
4
1
2
4
2
4
6
5