Installation Instructions – 4A92L *PLEASE READ ALL INSTRUCTIONS AND WARNINGS PRIOR TO ASSEMBLING, INSTALLING, AND USING THIS PRODUCT* Warning Always check for wires, fuel tanks and lines, brake lines and other important vehicle functionality items prior to drilling and installing all products.
Installation Instructions – 4A92L Step 1 – Load Plates • At the end of each bow, opposite from the pan mechanism, bolt load plates (J) using two 5/16” x 3/4” carriage bolts (1), two 5/16” flat washers (2) and two 5/16”...
Installation Instructions – 4A92L Step 2 – Pan Mount • Set Bow Assy (A&B) on mounting feet as shown. Follow instructions from the mount kit to install on vehicle. • Place a foam block from the packaging to hold the bow in the up position in order to access the mounting slots.
Installation Instructions – 4A92L Step 4 – Install Hex Tube • Install hex tube to front pan assembly. • Use the end of the hex tube assembly with 2 exposed holes to mount into the front pan. *Front bow shown* *Rear bow shown below* •...
Installation Instructions – 4A92L Step 5 – Install Latch • Move rear pan assembly out of the way to expose the end of the crossmember. • Bolt latch assembly (F) to end of crossmember using 5/16” x 3/4" carriage bolts (1), 5/16”...
Installation Instructions – 4A92L Step 7 – Ladder Stop • Using the hardware in both bows, bolt ladder stop (H) in orientation shown. Be sure to place the tab on the ladder stop into the slot on the bow. • TIGHTEN Step 8 –...
Page 10
Installation Instructions – 4A92L • The ladder hook may be adjusted up or down at 4 different locations. GO BACK AND TIGHTEN ALL BOLTS FROM PREVIOUS STEPS, BE SURE HARDWARE IN MOUNTING IS TIGHT. YOUR INSTALLATION IS NOW COMPLETE For Technical Support Call: 800-343-7486 Monday-Friday 7AM - 4 PM (PST)