Opera Ng The Heater; Turning On And Off; Room Temperature Adjustment; Auto Off - Rinnai FC510 Installation And Operation Manual

TURNING ON:
Press the ON/OFF bu on to operate the heater. The
ON indicator will glow green. A er approximately 3
seconds the spark generator will be heard before the
burner ignites and the ON indicator glows red,
indica ng that the burner is lit. Warm air can be felt
coming from the louvers approximately 5 seconds
later.
If the heater does not ignite on ini al try, air may be
remaining in the gas supply line. The spark generator
will only con nue for 15 seconds. A er this, it will be
necessary to press the ON/OFF bu on OFF, then ON
TURNING OFF:
Simply press the ON/OFF bu on to switch off the
heater. The ON indicator will go out. The convec on
fan will con nue to operate for several minutes a er
the burner has gone out in order to cool the
appliance. Do not unplug the appliance while the
convec on fan is running.
DO NOT turn heater off by unplugging. The
convec on fan will con nue to run as the appliance
needs to cool.
18
Opera ng The Heater
NOTE
again.
NOTE
Fan Convector Manual
Room Temperature Adjustment:
The room temperature and pre‐set temperatures can
only be displayed and adjusted when the heater is
Press the " " bu on to increase the temperature
se ng or " " bu on to decrease the tem‐
perature se ng.
The temperatures can be set to:
a) [L] low (minimum combus on)
b) [60°F] to [80°F] in 2°F increments
c) [H] high (maximum combus on)
(Default temperature se ng is 72°F)
If the heater does not ignite, then the pre‐set
temperature may not be set to a se ng that is
higher than the actual room temperature.
AUTO OFF:
When AUTO OFF is selected, the indicator light will
glow. The unit will now be under full thermostat
control. The heater will operate to reach the
selected room temperature and then turn OFF. Press
AUTO OFF again to disable this func on.
When AUTO OFF indicator light is not glowing , the
unit will con nue to produce heat in at least a low fire
capacity un l the unit is manually powered down.
NOTE
running.
NOTE
NOTE