Table of Contents
Advertisement
4.
Wait for the beep, and then repeat the digits using
a normal tone of voice. (The phone plays back
your first set of digits and asks "Did the recording
sound OK?")
If the recording is acceptable (no mistakes and no
background noises), say
softkey.
If you need to rerecord the digits to fix any
problems, say
"No"
or press the right softkey. (The
phone then prompts you to say the digits again.)
Wait for the beep, and then record the digits
again. (Repeat this step until you are satisfied with
the recording.)
5.
After confirming that the recording is acceptable,
repeat the recording process with the next set of
digits.
6.
Repeat steps 4 and 5 for an additional nine sets of
digits.
or press the left
"Yes"
7.
When you are finished with a full session, you will
reach a screen that reads, "Adaptation Complete."
You can either allow the screen to time out or
press
(left softkey) to return to the main standby
OK
screen.
Note
It is recommended that you perform the complete
adaptation of Digit Dial at least once to achieve the
maximum benefit of this feature. If a partial adaptation
is performed, you can always return later and resume
the process from the halfway point.
Resetting Digit Dial Adaptation
1.
While in standby mode, select
.
Voice Services
2.
Press
(left softkey)
Settings
Reset Digits
.
3.
Press
(left softkey).
OK
Section 2H. Voice Services
Main Menu > Tools >
> Digit Dialing >
89
Advertisement
Table of Contents
