Table of Contents
Advertisement
www.naneos.ch
The partector data file
To view the measured and stored partectorTEM data, remove the SD
and insert it in your PC as described in a previous section. Now you either
download the partector data analysis tool from the naneos website to view
the data or you open the data file with your favourite data analysis program
(Excel, Origin, Igor etc). The data file is a simple tab-delimited text file. File
names encode the recording time and device serial no. For example, if
nd
you start recording a file on 2
August at 12:35 with a device with the
serial no. 19, the file name will be stored in the folder 08_02 with the file
name 019_1235.txt. Parameters like relative humidity, temperature,
battery voltage etc. will only be recorded every 10 seconds.
The partector analysis tool allows you to quickly view graphs of all
instrument parameters, to average data in different intervals, and to
combine measured data with a GPS signal and plot it in Google Earth.
Read the separate quick guide on our website for more information.
Error messages
Whenever an operation parameter of the partectorTEM is outside of its
normal range, a warning message appears on the partectorTEM screen.
The warning shows up in red on the home screen:
Figure 9: generic warning message on home screen
There are different reasons for warnings to appear, and a click on the
"show" soft button will display details on the warning. Some error
conditions may disappear again by themselves (particularly such related
to high humidity), upon which the warning message will also disappear
again. However, it can be important to know that an error occurred, and
therefore, a red exclamation mark remains in the title bar as a reminder
that an error occurred at some point:
13 | 17
Advertisement
Table of Contents
