Failure to follow the instructions indicated in this manual, which is supplied with the appliance, could cause injury to persons, animals or damage to property. UNICAL shall not be held liable for any injury and/or damage. CONTENTS GENERAL INFORMATIONS .....................................
Any other use of this appliance will be considered improper.UNICAL declines any responsibility for any damages or injuries caused by an improper use; in this case the risk is completely at the user’s responsibility.In order to use the appliance according to the scopes it was designed for it is essential to carefully follow the instructions indicated in this guide.
Servicing or repairs of the appliance must be carried out by UNICAL authorised service technicians; UNICAL recommends drawing up a service contract. Bad or irregular servicing could compromise the safe operation of the appliance, and could cause injury to persons, animals or damage to property for which UNICAL shall not be held liable.
General information 1.6 - DATA BADGE CE marking The CE marking certifies that the appliance complies with: The essential safety requirements of the relevant gas appliances directive 2009/142/EC. The label is positioned on the external part of the frontal shell (to the left side). KEY: 1 = CE surveillance Notified ®...
Please read carefully the instructions contained in this manual as they provide important indications regarding the safe Any repairs must be carried out by Unical authorized installation, use and servicing of this appliance. technicians and using only original spare parts. Non- observance of the above requirement may jeopardize the Keep this manual in a safe place for future reference.
Technical features and dimensions TECHNICAL FEATURES AND DIMENSIONS 2.1 - TECHNICAL FEATURES The water heater IDRONIK TS 13 is an appliance operating COMPONENTS DESCRIPTION: on gas, with a two section burner which distinguishes for its • Two section burner extremely reduced depth: only 10 cm.
Instruction for the installer INSTALLATION ISTRUCTIONS 3.1 - GENERAL WARNINGS WARNING! The appliance must be installed only on a WARNING! vertical flat wall, made of non combustible This appliance has to be destined for the material. use for which it has been expressly The appliance must be positioned so that at designed.
UNICAL refuses all liability for injury to persons, animals or damage to property deriving from not having respected the above mentioned recommendations. In the packaging, in addition to the water heater, you can also find the following contents: - This installation and servicing and user’s manual...
Instruction for the installer 3.5 - WATER HEATER INSTALLATION 3.4 - WATER HEATER LOCATION Before connecting the water heater the following When selecting the position for the installation of the boiler requirements must be carried out by competent and qualified please comply to the following safety requirements: engineers: a) The system is flushed out with water in order to...
Instruction for the installer 3.6 - GAS CONNECTION As a safety measure against gas leaks, DANGER! Unical recommends installing a surveillance The gas connection must be carried out and protective system composed of a gas only by a qualified engineer who will have...
3.9 - SMOKE EVACUATION CONNECTION SMOKE EVACUATION WITH COAXIAL DUCT Ø 60/100 mm We recommend using only original UNICAL flue outlet systems. Type C13 Damages caused by installation errors and The minimum allowed length of the coaxial duct is 0.5 m.
Page 14
Instruction for the installer Important: The coaxial duct must have a sloope toward the outside of 2%, in order to allow to the outside the possible condensate. Example 1: LATERAL AIR INTAKE/SMOKE EVACUATION 2° 2° Example 2: REAR AIR INTAKE/SMOKE EVACUATION Minimo 500 2°...
Before the initial lighting of the water heater it is suggested to technician to check the appliance’s electrical system. check: UNICAL refuses responsibility for any damages arising from failure to earth the boiler correctly. the installation is in conformity with the relevant applica- It is necessary that a qualified technician verifies that the ble standards;...
User’s operating instructions ISTRUCTIONS FOR THE USER 4.1 - PANEL BOARD Ignition button Burner in operation Temperature setting push buttons Temperature value / Error code (+ increases and - reduces) Hot water available D.H.W. flow rate adjuster Fan in operation Drain valve 4.2 - USEFUL SUGGESTIONS AND Adjust the hot water flow rate ‘‘C‘‘...
Page 17
User’s operating instructions Adjust the water flow rate through the knob A too low or too high water presure can cause ‘‘C‘‘and the hot water temperature through the an anomalous combustion. button ‘‘B‘‘, according to your own needs. It is In these cases don’t use the water heater up to good to get familiar with the appliance commands when the water pressure returns to the normal...
Codes fault ERROR CODES LOCKOUT: The resetting is done by cutting the power, or by closing and opening the hot water tap. The appliance has integral diagnosis system that, in case of STOP: bad operation, allows the immediate indication of the fault is intended ignition not allowed (SERVICE) type on the panel board.
Page 20
- info@unical-ag.com The Unical declines every responsibility for the possible inaccuracies if owed to errors of transcript or press. Also reserves the right to bring those changes that it will hold necessary to it own products or profits, without jeopardizing its...
Need help?
Do you have a question about the IDRONIK TS 13 and is the answer not in the manual?
Questions and answers