Samsung RF4402d-D1A Installation Manual page 26

No. Name
24 Knife
25 Optical Connector Cleaner
26 Optical Transceiver Removal
Tool
27 Multi tester
28 Fiber Optical Test Set
29 Angle Meter
30 Antenna Alignment Tool
31 Multi master (VSWR & RF
Power)
32 Compass
The required installation tools may vary depending on the conditions at the site.
In addition to the basic tools, a protractor, ladder, safety equipment, cleaning tools,
and so on should also be prepared in consideration of the site conditions.
RF4402d Series Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Specification Purpose of use
Basic Tool Cutting
For LC Connector For Optical Connector Cleaning
Normal Separate the Optical Module
Digital Pocket Tester The voltage and current
measurements
Whether measured cable
disconnection
Wave length: 1310 nm, 1550 Optical level check
nm (single mode) 850 nm,
1310 nm (multi mode)
Normal Antenna angle measurement
- Checking azimuth and tilting
Normal Feeder VSWR measurement
Normal Check azimuth during installation
Confidential
Chapter 1 Before Installation
11