Introduction - Samsung RF4402d-D1A Installation Manual

Appendix C

Introduction

When connecting an optical cable to the system, the performance of the system
can be decreased or failures can occur if the core section of an optical connector is
dirty due to dust or foreign material. Therefore, operator should clean the optical
connector before connecting an optical cable to the system.
When using an optical connector cleaner, use the products shown in the example
below or their equivalents.
Examples:
Manufacturer-USCONEC (http://www.usconec.com)

TM
IBC Brand Cleaner (P/N: 9393): For LC-LC and MU Connector Cleaning

TM
IBC Brand Cleaner (P/N: 9392): For SC Connector Cleaning

TM
IBC Brand Cleaner (P/N: 12910): For ODC Connector Cleaning
Manufacturer-The Fibers (www.thefibers.com)

HuxCleaner 1.25 mm Type: For LC and MU Connector Cleaning

HuxCleaner 2.5 mm Type: For SC, FC and ST Connector Cleaning
Follow the manufacturer's instructions for cleaning the optical connectors.
Measure the Optical Output and Connecting the Optical Connector
To measure the optical output
Using an optical power meter check the optical output.
1
RF4402d Series Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Clean the Optical
Connectors
Confidential
115