Pride Mobility Go-Go Series Owner's Manual page 18

Table of Contents

Advertisement

BATTERY PACK
The Go-Go is equipped with an innovative, easy to remove battery pack. A handle on the top of the battery pack
makes it easy to lift the pack off of the scooter with one hand. The battery pack contains two 12 volt, 12 AH
batteries; the charger power lead receptacle; and the main circuit breaker (reset button). See figure 7.
CHARGER POWER LEAD
RECEPTACLE
Charger Power Lead Receptacle
The scooter’s 3-pin off-board charger lead plugs into this receptacle.
Main Circuit Breaker (Reset Button)
When the voltage in your scooter’s batteries becomes low or the scooter is heavily strained because of excessive
loads or steep inclines, the main circuit breaker may trip to protect the motor and electronics from damage.
n The main circuit breaker reset button pops out when the breaker trips.
n When the breaker trips, the entire electrical system of your scooter shuts down.
n Allow a minute or two for your scooter’s electronics to “rest.”
n Push in the reset button to reset the main circuit breaker.
n If the main circuit breaker trips frequently, you may need to charge your batteries more often. You may also
need to have your authorised Pride Provider perform a load test on your scooter’s batteries.
OFF-BOARD BATTERY CHARGER
The off-board battery charger, when plugged into the
charger power lead receptacle (located on the battery
pack) and a standard wall outlet, charges the scooter’s
batteries. See figure 7A.
18
I V .
Y O U R
Figure 7. Battery Pack
G O - G O
Figure 7A. Off-Board Battery Charger
BATTERY PACK HANDLE
BATTERY PACK
MAIN CIRCUIT
BREAKER (RESET
BUTTON)
Go-Go

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Go-Go Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents

Save PDF