Soaking; Timer - Speed Queen AWM472W2 Use And Care Manual

6. Set LOAD SIZE (WATER
LEVEL) control. Use RESET if
agitation has started and more
water is needed.
IMPORTANT: Holding the LOAD
SIZE (WATER LEVEL) control in
the RESET position can cause
flooding of the washer.
7. Select the cycle according to
the type of fabric being washed.
Push the timer knob
and turn clockwise to the
desired cycle and wash time.
8. Pull the timer knob out to start
the water fill. Agitation will begin
when the water reaches the
level you selected.
The washer will stop (pause)
for approximately two minutes
before the wash and rinse
spins. Do not turn the timer
through these pauses. They
are part of the cycle.

Soaking

Set the timer knob in the center of
the word "RINSE" or the washer
may spin without first filling with
water. Place the soaking product
and clothes load in the washtub.
Pull timer knob to start water fill.
After fill is completed and agitation
has started, push the timer knob
in. This will stop the washer.
When the clothes have soaked
the desired length of time, TURN
THE TIMER KNOB TO THE
START OF THE LAST SPIN, then
pull the timer knob out to start the
spin.
in
12

Timer

Although the washer cycles are
automatic, the timer may be reset
to lengthen, shorten, or repeat a
portion of a cycle.
To set or reset the timer, push
timer knob in to stop the washer.
Hold timer knob in firmly while
turning it clockwise to the setting
desired. Pull timer knob out to
start the washer.
36729